![]() ![]() Shipping and Packaging: It arrived quicker than expected and was packaged securely and tightly wrapped with a very large amount of packaging tape, as the box looked a bit rough and worn. However the contents inside were secure in foam packaging, with no damage to the product.Īssembly and Installation: It was very easy to assemble and did not take long to install to my computer. Suggestion Instructions and help are a bit unclear and difficult in certain sections, but overall understandable.Īuto-leveling is not reliable on its own. Manually level before auto-leveling for best results. Issues: I tightened the belts as much as possible and used the auto-level function as instructed. For a while prints were coming off very off center, patchy, incomplete, and rough and I could not figure out what I was doing wrong. I talked to my high school engineering teacher and we spent about two weeks troubleshooting, testing and calibrating. The main issues were belt tension and rod length. The rods holding up the extruder head are supposed to be EXACTLY the same length, down to a hundredth of a millimeter. Two of the rods I received were just slightly shorter and threw off the accuracy, but eventually I positioned them so that it is no longer an issue. Though the instructions say the belts must be tight, it doesn't mean they should be as tight as possible. With the belts too tight, they stretch over time, and the tension causes considerable bounce, throwing off Z level accuracy. This issue was corrected by placing a piece of standard copy paper on the print bed, and then using gcode software to lower the print head to 0.1mm above the print bed at one edge closest to a set of guide rods. I then adjusted the belt tension slightly and gently pull on the paper, and repeat until there is just slight resistance on the paper, but not enough so that it is hard to pull. (tighten belt to raise head, loosen to lower) I then repeated the process with the other two sets of rails. Afterwards, I pressed auto-level, and started a test print. Overall great printer, but not recommended It came out perfect, save for being 0.4mm larger in scale to what the model was supposed to be, but this can easily be fixed by scaling the model down by 0.4mm in the slicing software. There are two key factors which will affect the time you receive your items. 1 Item processing timeĪfter receiving your order,we require some time to test the product to ensure its quality.The exact processing time varies depending on the item.The average processing time is 3 working days.but this can also be affected by the item's stock status. Netherlands, Greece, Poland, Hungary, Slovakia, Czech Republic Spain, United Kingdom, Italy, Germany, France & Portugal Unregistered Air Mail or Registered Air Mail For small quantity orders,the processing time is 1-3days while larger quantity orders may require 2-5days. ![]()
0 Comments
Leave a Reply. |